Ratings & Reviews for Project Source 0.75-in x 25-ft Melamine Iron-on Veneer Edging
Ratings may include incentivized customer reviews.
What Customers Are Saying
The melamine iron-on edging tape is generally well-received, with customers finding it easy to apply and providing a clean, professional look. However, some users reported issues with the tape being too thin or narrow, and a few had problems with the glue bleeding through or damaging their iron. Overall, the product appears to work well when used as directed, but customers should carefully measure and ensure compatibility with their specific project before purchasing.
Customer review summary generated by AI, including incentivized reviews.Just what I was looking for
Would RecommendWorks as expected, I was concerned about the "Iron On" feature, but when I used aluminum foil it worked great
Simple and quick Melamine edging
Would RecommendI have used this product for over 10 years. It adheres quickly but can be re-postioned if moved immediately. I usually wear work gloves since the edging is very hot after application and sometimes needs hand alignment.
Product was easy to use and performed as described
Would RecommendI lined up one end with a corner and trimmed the other. A fresh razor blade works quite well for the final trim.
Cuts it short
Would RecommendOver all this is a good product. I would like it to be a little wider. Being 3/4" does not give a lot of overhang to trim off on 3/4" ply.
Only Lower's had what I needed.
Would RecommendI needed 1.5" wide edging but we used 2 of 0.75" edging to create 1.5" of edge. I did not use hot iron as recommended however, I used heat gun instead and it's work wonderfully. Adhesive is strong and easy to applied.
Does exactly what it says it does
Would Recommendbought this to go with a 4x8 sheet of melamine covered board. I made a craft table from it. This stuff irons on the edges that don't have the melamine on them. worked perfectly well and had no problems ironing it on.