Ratings & Reviews for Project Source 0.75-in x 25-ft Melamine Iron-on Veneer Edging

Goes on easy

Worked perfect

I'm not a painter or wallpaperer, but am doing the best I can to DIY. I wallpapered around a thermostat, and the wallpaper came out jagged around the edges. This edging helped a lot. I couldn't use an iron over the wallpaper or the plastic casing of the thermostat, so I used a hair dryer on high heat. It worked excellent. I recommend. Only problem I had with it is that the thermostat has rounded sides instead of straight up and down. I couldn't cut the edging to fit around, so there are s...

Will need an iron to heat product

Used for edge of counter top, product worked well. Easy to use just add heat.

Not the best I've used

This edging is very delicate and burns easily. I used parchment paper first and it glued itself to the melamine surface. I tried tinfoil next with the same results. I had a partial roll that I've had for several years and it is twice as thick and does not require a buffer between the iron and the edging. I can only assume they have made this product thinner to increase profits. I will not buy again.

0.75 x 25’ Melamine iron on edging

Product was easy to work with and remained attached to project edge. Only problem was insuring that you heated it sufficiently to melt adhesive without effecting color (white).

Tape does not stick to wall.

Tape did not work for what we purchased it for but it is great tape and I’ll find another use.

Quality product, stylish look

Quality edge banding. Simple to apply. Strong glue adhesion., Trims nicely. Make sure your iron is on a high setting. The glue on this banding is aggressive. You can reposition it for a few seconds but not much longer. I would also recommend sanding melamine prior to banding to eliminate gaps and create a flatter surface area for glue adhesion. Strong buy recommendation.

Check with me in 10 years!!!

Ironing them on went better than I expected. I'll have to see how well the edges of the melamine are protected.

Best I’ve Used

I’ve had to use veneer edging many times over the years. It’s never “fun”, but it is easy enough. This package of veneer, though, is the best I’ve ever used. It ironed on nicely and didn’t cause me any problems. I did have to trim it for the narrower edge I was using it on, but even that went easy once I realized that I needed to make sure it was fully ironed down AND cooled completely. It almost makes me wish I had so more edged to cover. Almost.

Awesome product

Great edging!

Ruined my wifes iron

Horrible not oversized so have to put on exact. Also glue bled through, ruined the iron. I am not new at this been using another stores product at least 20 times

Works as expected

Used to cover up edge of plywood for Murphy bed. Was a little hard to cut the excess that hangs over but looked good and took paint well

Easy to use

Worked as advertised.

trash

embarrassing that they even pushed a product like this out. it's basically a strip of paper with some glue.

This edging does not look that good. I much prefer

The edging glued nicely but