Ratings & Reviews for Yardsmith Metal Male hose repair

Works Great !!

I saved money using this to fix a hose that had a leak. I cut the hose n put each end onto its ends and tighten with a screwdriver. It takes a little effort to push the hose all the way on, but ones the screws are tighten it stays together!! It is also REUSABLE which is a big big plus in my book!’n

Works Like a Charm

This was an economical way to repair my 100’ water hose that sprung a leak. So easy to do even for me, a lady of a certain age!

Darn lawn cutter

Lawn person was trimming lawn and cut a good hose. Even though this was not the most cost effective, this item did a great job fixing the hose! I've used them several times,and they did now leak or have any other problem.

As intended

Does the job, does not leake and withstands being dragged on concrete

Hose connection

Self explanatory. Worked like a charm. Saved me buying another hose.

Leaks

Connector is very well made. That said, I've used hose repair connectors like this (except plastic) for years and this is the first one that just won't stop leaking even after trying several times to reseat both ends and re tightening the screws. I was using 5/8" hose.

Durabel and Easy to Install

Had a hose with a small bad section. Cut it out easily and installed this metal hose mender to splice together. It was easy to install and being metal makes it very durable. The metal mender gives a tighter grip on the hose compared to plastic.

Ok, but

Perfect for a few hours then leaked, not a lot but some.

Sturdy Connection

A neighbor who I permit to hay on my ranch complained to me that I had left a huge, high quality, red, highly visible 100 ft. hose in a garden area on my land, such that he chewed it up with his tractor. It was annoying that the repair was left for me, but with this very heavy duty connection that looked to be way too small, I was able to make a repair that was almost as good as new!

Quick fix for a leaky hose

Easy to install. Just cut out the leaky section of hose and slip on the coupler at the opposite ends of the cut section and tighten the screws and your ready to go.