Ratings & Reviews for DEWALT Titanium Nitride coated HSS Oscillating Tool Blade

Weak

One star for the brand, one star for the first five nails. After that it it wouldn't cut anything.

Clean cutting machine

These blades are great, they’ll cut through anything without the vibration of a full-size Sawzall. Very easy to control and sharp. Now you won’t be able to use this like a sawzall it will dull quickly in plaster and other semi hard materials.

Trandition pieces

Perfect to cut laminate flooring to put in transition pieces

Defect in materials

Bought this to trim a 3/8th in. rusted bolt and used it once and it chipped a section of teeth. Took it back to Lowes and got a replacement which finished the job and seems to be working just fine. Might rate it higher if not for the chip.

Blade dulled rapidly

Purchased blade to cut through wire mesh on old ceiling and wall construction and blade dulled very rapidly. Tried to use it to cut off screw heads without success. Other brands performed better but Dremel brand was even worse Might work ok on wood and light brads but not for our heavier metal

It’s the best.

Five stars! It’s the best. The saw blades are expensive though.

Terrible

Halfway through my first nail I am looking to make sure I have the right blade. Unfortunately I do... Wow. Unexpected from Dewalt.

Pretty good

Cuts through metal well can’t handle hard pallet nails though. Dulled immediately with pallet nails. Kind of disappointing for that job application.

oscillating tool blade

cuts great. long life.

Metal Cutting

I had some nails in the back of an old dresser that had been repaired incorrectly. I needed to cut the nails and there was no other saw I had that could get to them. I had never tried cutting metal with the oscillating tool before. For that matter I didn't even know they made blades for cutting metal till I went looking. Anyway, I got one and it worked great and problem solved.

Not worth the extra money

This blade was done in 15mins just as bad as the bimetal blades. I don’t expect these blades to last forever with cutting aluminum like we do every day but 15 mins is unacceptable IMO. I will just buy the cheap harbor freight blades from here on out.

Tough on Brad nails

Used the heck out out it and it is still cutting through the nails

Oscillating Tool Blade

Bought this to cut out a hole to mount an exterior plug on a neighbors shed. It worked great. Quality tools give quality results. Thats why I do all my hardware shopping at Lowes. Recommend this is if you are going to cut holes with a multifunction tool.

Sorry Dewalt - poor quality

"Lame" Reviews are right. This one wears out FAST! I used a $40 2-pack (Rockwell or Bosch?; thicker too!) earlier in my job. It was awesome. I went to cut one 5/8" bolt off and I got 1/3 into it. The other brand did the whole bolt. Aka: 3x better blade! Wasted $20 and a trip to the store.

Blade

Great for cutting nails in frames, etc. Worth the few extra dollars.