Ratings & Reviews for DEWALT Titanium Nitride coated HSS Oscillating Tool Blade

Fast Cutting MultiTool Blade Does The Job

Purchased one of these blades for my multi-tool to cut away the screw housing on a stainless steel hose clamp in a tight quarters location. It did the job quite quickly and with good precision.

Worked well for cutting nais.

A cut above

I bought this while cutting the bottoms off door jams before installing new flooring. The wood-only cutter lost all its teeth after encountering a nail. Using this cutter, the nails and door jam molding were no match. Stayed sharp for the half-dozen doorways I used it on. Do not try to use it for the outside corner metal drywall protector - it will just vibrate and ruin your spackle. I suggest an angle grinder with a diamond blade for that.

Waste of money

Bought this blade and a comparable Dremel version because I had a little bit of red brick poking out at the base of a fireplace and needed to trim it to neatly install a tile hearth. Two blades, same price. Started with the Dewalt and in pretty much no time the teeth were gone and it was useless for the project. Switched to the other one and had no problem trimming the protruding brick on both sides of the fireplace.

Exploratory cuts

Prefect for making the smallest exploratory view cuts into areas of unknown materials.

made the cut

This got through the 7 roofing nails I needed to cut off some 2x4's. It wasn't super fast, but eventually it worked. I had initially bought a cheaper no-name version (half the cost), but it didn't cut through, so this DeWalt one is much better. Worth the price. It fit nicely in my Dremel MultiMax.

Last long time

Blade lasts a long time. Wears well. Cuts well. A bit pricey, though.

Failed on first use..I should return what's left

It actually broke trying to cut through conduit...

Worked well

Not much to say. Works well and fit In my Harbor Freight tool.

Bathroom job

I had to replace a bath light and Vent combination. The old unit was strapped between the sheet rock and the ceiling joist. This blade on my Dewalt Cordless cut the old straps quickly and smoothly even with the joist edge.

Doesn't last

I didn't make it through one piece of barn door track before it wore out. It is not good for cutting steel bar and for the price I paid for it it should have lasted longer.

I WANT MY $20 BACK!

bought this because the package said for metal, wasted trip and wasted money. I want my $20 back

Soft metal only

It cut 20 roofing nails and its garbage. That's $1 per nail

Soft metal only

Cut off 20 roofing nails with this. No teeth left, I'm not impressed.

Terrible Blade

Bought 2 blades to cut out old flooring. Blades only cut 2 boards each before teeth were gone. Will never buy this blade again.

Wore down teeth after 2 small cuts in thin metal.

A bit disappointed with this blade, especially for the price. I used it to cut two rectangular holes on the back slide of a metal cabinet. The holes were about 2" by 4". The metal thickness was about 1/16". Already dulled the cutting teeth.

End Cutter blade

Got this blade specifically to cut nails when removing trim. It worked perfectly.