Ratings & Reviews for Project Source 0.75-in x 25-ft Birch Iron-on Veneer Edging

Great for a small repair

I used this to fix a corner of a used dresser that was dropped during transport. It worked out that the strip came in the exact width I needed. I used a stain marker to match the color of the dresser. I followed the directions and it was easy to use. I needed a couple tries to make a perfect cut. It was easy to remove and start over by reheating with an iron.

Pretty up drawers

Perfect way to finish off my new cabinet drawers. Lets me easily cover the cut plywood edges with something that looks nice when the drawers are opened.

Birch Veneer, would re-buy

used this to cover the side of a piece of plywood to make a shelf. It went on nicely and remained in place.

Didn’t adhere well the first time.

Easy to use but it did peel off after a few days in some spots. Not sure why but just had to re heat with the iron and that seemed to fix it.

Easy application

This was my first application with this product. Easy, results were very favorable. I was concerned about using my wife's iron for this, so I bought a cheapy $10 one. While it worked perfectly, using any household iron would be safe, no ill-effects on the iron, just follow the heat instructions.

Blends in well with plywood

Worked great for a plywood work bench top. Used it to seal the edges and it looked like it was meant to be there all along. Product was easy to apply using an iron for the heat source and the glue activated without too much effort. Just what was needed to finish off the project.

Easy to use

Easy to trim, stain and finish to match my refaced cabinets. The heat-activated glue backing melted quickly and stuck to my kitchen shelves very well. Looks great.

Can be a pain on curves

My project had several curves. This stuff is a pain in the back side to iron around curves. As far as looks go it matched the maple plywood perfectly.

wood ribbon

the adhesive works well. the wood ribbon is very close to to the size of the wood. very little to shave

Looks Good

Bought this to cover the edge of Birch Sanded Plywood board that I also bought from Lowes. So far, so good. I finished it with the rest of the board using Danish Oil. My go to finishing product. It took the "oil" well. The edging is holding well. I am sure it will peel off in time...hopefully a long time from now.

edge banding

Very easy to use. All you need is an iron and trimmer. Works great. Been using this product for about 12-13 years. Would recommend to anyone

Birch Edge Banding

This was my first attempt at edge banding and it was much easier than I expected. The edge banding was easy to cut and attached quickly with just an iron. After it was applied, it was easy to trim to the correct width even without the dedicated edge band trimer (I just used a utility knife).

Exactly what I was looking for at a good price

Exactly what I was looking for at a good price. Also the product worked great. And it matches perfectly with the plywood. I can’t wait until spring to see how it does with stain.