Ratings & Reviews for Project Source 0.75-in x 25-ft Birch Iron-on Veneer Edging
Ratings may include incentivized customer reviews.
What Customers Are Saying
The veneer edging product appears to be an effective and easy-to-use solution for covering plywood edges. Customers report that it is simple to apply using an iron, adheres well, and can be easily trimmed and stained to match the plywood, giving a professional, finished look. The key benefits include strong adhesion, the ability to stain and finish the edging, and the transformation of plywood to look like solid wood. While a few customers had issues with adhesion or the roll being stuck together, the overall sentiment is very positive.
Customer review summary generated by AI, including incentivized reviews.Easy to apply
Would RecommendWorked great. Easy to apply and it looks really good. I would definitely buy it again.
Verified Purchaser
Read the directions and take your time
Really good product if you take your time and share it correctly
Verified Purchaser
Works great
Would RecommendVerified Purchaser
Easy to use.
Would RecommendEasy to apply and trim to fit.
Verified Purchaser
Worked perfectly
Would RecommendWrapped around a round piece of plywood that is a support connection piece under a table just to help the project look more finished. Went on easy with regular house iron, excess cut off easy, edges sanded smooth and took stain and poly without any issues.
Verified Purchaser
It's wider than the plywood is.
Would RecommendIt works just fine. It's a lot wider than the plywood so it took some time to get it done with a block plane.
Verified Purchaser
Does its job. Easy to apply.
Would RecommendWorks well to cover edges. Does have some glue seams that might show depending on the application.
Verified Purchaser
Not as sticky
Would RecommendGlue was not as sticky as the glue is on the oak veneer
Verified Purchaser
need 2 people if doing a long edge
Would Recommendworked well to finish the edge of shelves
Verified Purchaser
N
Would RecommendN
Verified Purchaser
Poor Edge Banding
Would Not RecommendThis edge banding has very visible seams every couple feet (but not uniformly spaces) that not only look bad, but cause cracking along the length of the edge banding and pull up at the seam. Unless you're using it for very short pieces and can cut around the seams I would avoid!
There was a lot of veneer splice.
Verified Purchaser
Looks good but tricky
Would RecommendReally helps finish plywood edges. Getting the edging to stick takes a bit of finesse. I used a small hobby iron set on hi to medium hi. On compound curves, it helps to hold it in place after removing the heat.
Verified Purchaser
Good product
Would RecommendThe glue sticks well. Some of the products you buy online may look good but the iron on glue does not stick.
Verified Purchaser