Ratings & Reviews for MonoSystems 5-ft x 2.5-in PVC Silver Overfloor cord protector

Doesn't lay flat

Unrolled this cord protector a couple of weeks ago - still not laying flat - using it on hardwood floors so not wanting to use the double-sided adhesive since it would likely ruin the floor.

Perfect!

I needed a quick way to temporarily cover two ethernet cables strewn across the room and this works fine. I didn't use the included tape but it's heavy enough to stay flat anyway. Some people mentioned it's too stiff to unroll. Easy fix that takes no more that 10 minutes: 1: Take it out of the box but keep it rolled up. 2: Put the roll in a sink of hot water. Not boiling, just the hottest water that comes out the tap. 3: Let it sit in the hot water for 1-2 minutes. 4: Remove from the sink. It s...

Cord Protector

The channel for running cords is smaller than I anticipated. I was able to run a two wire extension cord and a cat 5 ethernet cable, but it was a tight squeeze.

Christmas Wiring

Used this item to place extention cords across a side walk and eliminate a tripping hazard for the season.

Chord hider

The material is stiff and sturdy but the way it is rolled up in the box prevents it from sticking flat, will return it.

Cord protector - the channel is small.

I was able to get a Cat 5 and a Coax cable in the channel but just barely.

Protection strip

Great product however when it’s rolled up in the box it’s difficult to get it to lie flat

Not deep enough for round(coaxial) cable. Glue not strong enough to stick down good to floor. Strip should be 6' (accommodates two 3' openings).

Perfect! A very convenient and effective design

We’ve only had it in service for a couple weeks (on a very smooth, non-porous vinyl-surfaced floor), but I’d say that this is a great product if installed correctly on a suitable surface. 1)Use a heat gun (start on lowest temperature setting) [or, maybe, a hair dryer on its highest setting] to help uncurl the protector. Be patient. In about 15 minutes you’ll have it lying perfectly flat. I’d guess that this is critical to getting a satisfactory installation. 2)Before applying the included doub...

Overfloor cord protector

Works well. It was hard to control at first due to being rolled in box. I laid it outside and let the sun heat the rubber, so I could flatten the cord protector. Really would like more color choices. Gray was the only color available at the time.

Won't lay down completely

Purchased this to cover up a cord that ran into the living room. The double sided tape will not adhere to carpet so, it keeps rising up on both ends

Adhesive needs work

Rubber is quality, the adhesive strips don’t hold well.

Great Product

Easy to install and provides a slick and elegant look to the floor area.

Perfect for my office

I need to run computer cables across the floor to a monitor mounted on the opposite wall. This was perfect. Low profile design no one trips on it...at least yet! LOL. Great buy!

Perfect Hideaway

Love this strip.....can cover the bright orange cord with mulch....to the pavement,then use the grey strip to hide the cord going over the pavement.....did it at two places.......perfect!