Delta Stainless Steel Single Handle Wall-mount Pot Filler Kitchen Faucet

Beautiful Fixture

It's a Delta, nothing else to say. Matches the other faucet perfectly.

Love the way it swings so freely and perfect for our needs

Repair leaking swivel.

Pot filler repair. Leaking at the swivel. Three, #80 rubber O-rings. Use allen key to remove two screws on the wall plate. Turn potfiller counter clock wise to remove from wall. On the bottom of the swivel, there is a decorative plate that can be removed. Once removed, there is an allen bolt. I think it’s 1/4” allen wrench. It’s very tight. I had to use a vice to turn the bolt. Once loosened, you can pop out the stem and there are 3 rubber o-rings. Replace those with #80 size o-ring. Make sure...

Replacement o-ring size for swing arm in review.

Love my pot filler 1177LF ! Delta however does not offer replacement o-rings when it started leaking but I found what I needed and repaired it. I disassembled my leaky pot filler and measured the o-rings in the arm joints where it was leaking with a micrometer. There are three o-rings per swivel joint. Based on my measurements I ordered Rubber O-Rings size 20mm OD - 14mm ID and 3mm Width from AMZ. You need six but order extra if you damage one during install. The replacement was easy. Turn...

Leaks

We have only had this pot filler for a few years and it leaks from multiple spots.

Warranty doesn’t apply before 2019!

Warranty only applies to faucets manufactured after 2019. Mine worked great for seven years and then sprung leaks everywhere. They don’t make the parts for repair so we’re out of luck.

Leaking and I'm told that it's garbage

this is leaking from the middle joint and i'm gobsmacked that there's no possibility of repair.

Horrible Quality

Double T fitting cracked and spewed water after a few years of use.