Ratings & Reviews for Reese 0.16-ft x 0.66-ft 700-lb Capacity Loading Ramp

Reese or Ramparts?

First, the closest Lowe's is an hour away, so being able to order online with a minimal shipping charge for orders falling below the minimum threshold is a blessing. Anyway, I've had a pair of Ramparts ramps for many years, only they are where I'm not; another set was in order. No one offered them locally that I could even order. I found a set by Reese, which I trust as a reliable company, at Lowe's for a good price. Anyway, ordered on Sunday and got them two days later. And, inside the Reese bo...

Great product

They work great for my truck and you can’t beat the price. Better than paying 150 for a pair that do the same thing

CHEAPEST RAMP....YET VERY STRONG

Great product, for much lower cost than complete metal ramp.

Great!

I was looking for something to make a ramp for our new shed when I came across these and couldn't be happier. My shed door is about 18" off the ground so I used one 8' long 2x8 cut in half so each board is 4'. If you are going any higher than 18" you're gonna need longer than 4' ramps (instructions have a chart to calculate the optimal length and it says I should have used 5'10" planks but 4' worked fine). Instructions were clear and install was simple. I added a strip of 2" wide grip tape down ...

Aluminum loading ramp

Very easy to install. Comes with all the hardware. Used it to put my wheelchair in my van.

Good product, works well

The ramp kit is just what I needed, it is built tough and easy to assemble. Drill four holes, tighten four bolts and done in less than an hour. P.S. Great and friendly service at my location (especially Tom who took the time to try and repair my retractable keychain while I was in-store). Thanks Lowes.

Very useful product.

I have purchased this product several times over the years. It has worked great to ramp my motorcycles into the back of my truck and up porch steps. There are pre drilled holes to help better secure to whatever surface you are resting the ramps on. All hardware is included and installation to your ramps is a breeze.

Easy shed ramp

After drilling a couple of holes and tightening up the provided bolts you have ramps. Have a piece of plywood cut to your liking and screw it on the planks with galvanized screws. Very cost effective easy ramp.

Quick fix

Needed ramps to load an ATV. They worked perfectly!

Aluminum Loading Ramp

This is my second pair. I bought the first years ago and used 2X8s to get my tractor into the shed. I bought this pair for my daughter to allow her to push her lawn mower onto her porch for storage rather than having to life it onto the porch. She loves it as I love mine.

Works just as good as the steel ones buy 2 solid treated boards and a little elbow grease

Does the job

Does not fit a 2x10, you will have to file down one end of your board to get a good seating.

Loading Ramps

Bought these to make a Ramp to put my riding mower in my shed. They worked out great with the 2 X 8 board I bought with these. Very please with how they were just the right angle to fit the floor on my shed. Reasonable price seem very sturdy.