Ratings & Reviews for J-B WELD KwikWeld Gray Epoxy Adhesive

A waste of money. It doesnt work!

First it doesn't come out in eaual proportions in turn won't mix both compounds together when pressing down on the plunger. The material will never harden until equal distributions of both sides of the tube are blended enough to set the material. Second it is a huge mess. Pretty much once you started to use it, you really need to finish the tube. It won't take long to have the small amount of material run out rather quickly. Third, it doesn't hold any more than if you used scotch tape.(holds for...

If you can't fix it quick weld it

Followed directions as told, just waiting to see if it holds then I can read it after a while

Great Product

Easy to mix and sets up (as stated) within six minutes. It Created a strong bond for a difficult repair.

No more leaks

I used this to seal an antique watering can/pitcher/ewer. It had multiple leaks that i was all able to seal

Works great

A storm broke a few of the ribs on my deck umbrella and this was enough to hold them together. It's a lot easier than the separate tubes and trying to mix them, but the first time you use it there is a good chance that the proportions will be off. Make sure you tap it down so that all the fluid is at the nozzle.

As strong as screwing it in! Durable too!

Amazing hold!

This worked for what I needed it for. I needed to fill a crack in my metal outdoor faucet. I applied it to the inside of the faucet, so it wouldn't interfere with the faucet threads. The only problem I encountered was when I was dispensing the product, one side came out seconds before the other side. You are supposed to use equal amounts, so it made it a little more difficult, and I wasted some of the product.

Trash

Doesnt work. Followed directions and used it to fix a small garden trellis where the welds popped loose. About 3/16” wire is what it was made of. Let it sit in the garage for 3 days. Go to check and it looked good. Bumped it against my son’s bike (barely) anf all 3 spot fixes popped loose. Completely worthless.

Quick patch repair on mowing deck.

Used this to fill a small hole in a mowing deck by using this to laminate a cut piece of sheet metal over the existing open. Worked well to bond this piece, would use it again for like repairs.

Subfloor Patch

I had to patch a 3" hole in the OSB subfloor. I mixed the epoxy with a lot of sawdust (like I do with wood glue to do smaller filler). It works great. The "Metal Reinforced" version! I've always used J-B before and tried Gorilla brand once and didn't like the way the tip was designed.

useability

Single top makes it nearly impossible to control equal amounts of hardner and solution. When attempting first usage black came out quickly about half inch amohnt before other solution started which delayed start and continued to come out slower this impacted equality significantly impacting drying time and may have impacted strength.