Ratings & Reviews for Deck Plus #10 x 2-1/2-in Composite Deck Screws 375 -Per Box

still wating

5 days later no refund. terrible

Good Deck Screw with One Flaw

These are good deck screws for composite decks. The thread pattern allows the screws to drive through the deck boards and below the deck board surface. Two things led me to give four stars instead of five stars. First, pilot holes are needed (unless you want to spend a lot of time trying to get the screw to "bite." Two, about one percent of the screws had their heads break when driving deep into the boards - especially when backing out screws. Overall, I recommend these screws.

Almost Always Strips

The color matches the decking (Trex Foggy Wharf) sufficiently. They appear to be well coated. Don't try to drive these without pre drilling. The WILL strip out. A total waste of time. I have never had deck screws that were allegedly designed for composite lumber strip out. The description says that you don't have to pre drill; good luck. I thought that the bit included was junk but my own T20 bits did the same. Do not buy these to save time; you will most certainly need to pre drill. I c...

Minor design flaw?

Its a screw but when using them I felt that it created too much vinyl garbage at the top of the screw which frequently prevented it from seating properly. This is generated by the reverse threads intended to prevent mushrooming. Perhaps the pitch on that portion of the screw could be improved. In any case there were a number of times when the screw would not seat and I was forced to back the screw out to remove the glob of melted plastic from the top of the screw and then put the screw back i...

heads strip before even half way in

Do not buy these if you don't want to spend hours fighting them. I tried multiple bits and drill/drivers and even pre-dilling but no luck. about 1 in 3 would strip out. Finally gave up and bought different screws which went in without issues.

Work great

Good quality

Pre drill

Nice screws, not self startimg has suggest. Pre drill for best results.

Exactly what we needed

Great Product

Had to use a 5/32 bit to predrill holes but that worked great.

The color matches the composite wood

Matches the composite wood so it doesn't look out of place

Head strips easy

Never used a screw where the head strips so easily. I wish Lowe’s offered a different brand of color matched deck screws.

Don't Buy

I finally stopped trying to make these screw work. I drilled piolet hole and changed bits, never got one all the way in without it stripping.

Trash as usual

Heads strip far too easily during installation and/or removal. 20 years in the trades, I know how to properly drive/remove a screw. I should have stopped and gotten different fasteners when these were stripping upon installation. Haste makes waste. Just spent the last 3 hours removing 4 deck boards I put down only a few months ago. I could only back out roughly one out of three screws, leaving me to try to drill out the rest. Went through a handful of drill bits trying to drill them out with mix...

Strips Way Too Easily

Even with pre-drilling, I found that 10%-20% of my screws would strip, regardless of what I did. At first I thought maybe I had a defective bit, but then I read reviews of others having the same problem. I hope I can return these!