Ratings & Reviews for Bosch 3/4-in Carbide-tipped Straight Router Bit

Smooth Cut

Worked brilliantly to help me cut out the hole for my sink in my countertop (corian)

Worked flawlessly

Used one of these bits to route a hole in a vinyl fence post for a horizontal rail. First, I made a jig out of oak, then clamped it to the post. Took hours to make the jig, but after only a few minutes with this bit in my router, that post had a perfectly cut and shaped hole for the rail piece. Use a hardwood for the jig so the bit's bearing stays true.

Router Bit

Greta bit for light dado cuts

Bosch 3/4" Carbide Straight Bit

This bit performed very well cutting 1/2" deep grooves in plywood. The bottom and sides of the grooves had a smooth finish without any tear out.

Sharp bit

Bit worked well to cut out handle in a cutting board I made

Good Router Bits

Bosch seems to have very good router bits. This one performed as expected. The scale printed on the side of the bit is an interesting wrinkle.

Great Quality

I have been using these Bosch bits for a couple years now and they are great and priced right.

Router bit

High quality precision cut that worked perfectly for a set of shelves I am making.

Does what it's supposed to do!

Cuts nice and clean - just what I needed it to do!

Great Router Bit

I love this bit. It has depth measurements printed right on it for ease of setting.

used for hardwood

seems to stay sharper than other brands I have used.

Good bit

Can't go wrong with Bosch, despite it being made in Taiwan. At least it wasn't made in the China where most of our products come from. An extra star for it's country of origin. Worked as I would expect, and appears to be very rugged. Did it's intended job well.

Would expect nothing less from Bosch.

This bit worked as expected, and is a step or two above the run-of-the-mill router bit. The price was good, and I expect it will last an acceptable amount of time. This product is not made in Germany, but it was made in Taiwan, which is NOT the China where most of our products come from. Which is why this got an extra star.

Excellent product

I purchased this bit for cabinetry. Very easy to install, and the blade is super sharp.

Bosch Carbide-Tipped Bit 85682MC

Out of the box, the Bosch carbide tipped router bit seemed to be exactly what I was looking for. In building a set of deck stairs, I needed a bit that would cut a clean, consistent depth dado in stair stringers to accept the stair treads. The blades were very sharp and maintained their sharpness throughout each cut. It chucked easily in my router and the bearing ran free and smoothly. However, after cutting about six dado's out of the twelve that were required, the bearing vibrated loose and sh...

3/4" carbide straight bit

I used it in my router with a jig to flatten the surfaces of an end grain cutting board.It worked well.