Ratings & Reviews for BORA 50-in Wtx 150-lb Bar Clamp

Adjustable Stop Moves While Cutting

I write a lot of reviews but rarely write a bad one. This product is almost a five because it is so low profile and has a nice clamp. Unfortunately the adjustable stop moves while cutting and sometimes will not release when you want. It only uses two small rubber-like brake shoes and doesn't have a decernable click when you try and adjust to the needed position. Once saw dust gets in the grooves it really slips easily. I have to give it one star since is costly to waste material and it is ...

Great Product for Saw Alignment

I used the clamp as a saw guide for cross cutting the table top and bench seat. It was easy to setup and worked great.

Bora 50 inch clamp guide

Disappointed to find this product was damaged after I had used it. It was damaged near the end opposite of the fixed clamp. Also the holding power is a little weak.

good product

When used by itself is a great tool, combined with the extension does not work at all.

Love it so far!

I purchased this clamp and the circular saw base to help with a furniture repurposing project for my daughter. It has been a great help in keeping my cuts straight and true.

One man operating helping hand.

Helps a lot when doing projects on your own. Like having a buddy to help you.

Straight Lines

This is an easy clamp that works great to guide a skill saw for a nice straight cut. Very easy to use and effective!

Good clamp, fixed end could be easier to use

This works as advertised. The fixed end (non-clamping end) is difficult to adjust but it is doable. Get the extension so you can do the 8 foot cut on plywood.

Bora Straight Edge Clamp

Great for light use. Not very rigid but will do the job with light use.

Nice straight edge for medium hand cuts

Not self-squaring, but does the job for medium cuts with any circular saw, not just Bora system.

Straight cuts yes!

This product worked great for guiding my saw!

Plywood clamp

This thing is downright a NECCESITY when using a skil saw to cut plywood, my wife and I have used it a ton so far. I love this product!

Not to impressed yet...

Haven’t used it to much, but so far not impressed yet.

Great product

The only thing I’d change is making it thicker so the saw edge didn’t ride up on it.

Clamps tightly

A couple of reviewers said it slipped. I have never had a problem of it slipping and wonder if they had it completely locked. The lever needs to be fully up to start, set the stationary end on one side of the stock and move the sliding end to the other side. Then lock the clamp by pushing the lever down and under the rail. On my last project I had to make precisely positioned dadoes in several separate boards. T lined up the end, locked the clamp in place and pulled hard against the clamp with ...