The Oatey Standard Retrofit Master Flash® roof flashing is an adjustable rubber pipe flashing with a soft aluminum base that is able to mold to profiled metal roof panels from 1/4-in up to 4-in diameter. Most commonly used with an existing roof penetration when installing over the pipe is not an option.
Most commonly used with an existing roof penetration, when installing a flashing over the pipe is not an option and requires a hard to reach or wrap-around installation
The 8-in x 8-in soft aluminum base is engineered for profiled metal roofing systems at any pitch
Made of non-fading EPDM rubber for higher resistance to ultraviolet light and extreme temperatures with up to 212 degrees (F) of continuous heat
Easily customized to accommodate a broad range of vent pipe diameters from 1/4-in up to 4-in diameter
Use silicone sealant between base and surface, and secure with sheet metal screws
Approved for Type B Installations
Comes with plastic snaps and a plastic zip tie for a secure installation