Two-Tier Patio Water Fountain

After the caulk has set for an hour, turn the pot over and seal around the stoppers from the underside. Take care to avoid pushing the stoppers loose with the tip of the caulk tube. Allow the caulk to dry overnight before continuing.

Place the plastic saucer on a piece of scrap wood and drill a 1-1/8-inch hole at the center. Hold the bit steady to avoid accidentally cracking the plastic.

Place the large pot where you’ll want your fountain. Turn a plastic pot roughly 7 to 8 inches tall upside down and rest it on the bottom of the large pot. With the extension tube installed, rest the pump on the top of the overturned pot and fill the large pot with water to about 1 inch below the rim.

Fully extend the pump tubes and center the pump to allow the tube to pass through the hole in the saucer. Position the saucer so the rim is evenly supported by the inside of the large ceramic pot.

Place the smaller ceramic pot on the saucer with the extension tube coming up through the drain hole of the pot. Work carefully to avoid accidentally pulling the extension tube free of the pump.

Select the nozzle of your choice and install it on the end of the extension tube. (The fountain kit comes with three options.) With water in the bottom pot, you can experiment with different nozzles to find the pattern you like.

Spread the rocks on a hard surface, such as a driveway or walk, and rinse them with water until they’re clean. Place rocks in the saucer to surround the upper pot. Then add rocks to the upper pot until they reach the nozzle.

Plug in the fountain and adjust the nozzle as needed. Check that the water doesn’t splash outside the saucer and drain the fountain.

Explore more water feature projects:

DIY Garden Fountain

Deck-Top Pond

Concrete Sphere Fountain

Soothing Water Fountain