Welcome to Lowe's
Find a Store

Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

Wood Square Circle Wall Art

Create a graphic piece of wall art with a square of plywood and sections of craft board. This design will look good in a bedroom, living room, or any other room.

Wood square circle wall art

Project Overview

Skill Level


Estimated Time

1 day

Estimated Cost


Tools and Materials


  • Wood glue
  • Table saw
  • Sandpaper
  • Framing square


  • 1/4" x 2' x 4' Sanded pine plywood, #7702
  • 6 - 3/8" x 4" x 36" Select pine craft board, #50235
  • 8 - 3/8" x 3" x 36" Select pine craft board, #50232
  • 3 - 3/8" x 2" x 36" Select pine craft board, #50227
  • 2 D-ring hangers, #264577

Items may be Special Order in some stores. Product costs, availability, and item numbers may vary online or by market. Paint colors may vary slightly from those shown. Availability varies by market for lumber species and sizes.

Missing anything? Shop Online


Step 1

Have a Lowe's associate cut your plywood to 2' x 2'.

Step 2

How to mark off lines on plywood

Use a 3/8" x 4' craft board to draw two light diagonal guidelines from corner to corner. Next, draw horizontal and vertical lines through the center of the diagonal lines, dividing the plywood into quarters.

Step 3

Sand the plywood using 120-grit sandpaper as needed. Then cut all the craft boards to length and width (Cutting List). Sand the ends smooth, group them by size, and set them aside.

Good to Know

To avoid rounding over the ends of the craft boards, stack the four boards of each size with the ends flush and sand all four at once.

Step 4

Center the 34" craft board on the plywood and mark where it overlaps (about 5"). Apply a bead of glue from mark to mark, and center it vertically on the plywood, dividing it in half.

Step 5

With the two 16-7/8"-long craft boards, apply glue to one edge (minus the 5" overhang) and one end of each. Place them perpendicular to the 34" craft board, one on each side, so they are centered horizontally along the plywood.

Step 6

How to use spacers and attach craft boards

From craft board scraps, cut four spacers 5" long and 1-5/8" wide. Stand them upright against the sides of the horizontal and vertical boards while you glue and press the next size boards against the spacers to create an L shape. Glue the longer section of the L to the plywood first. Then glue the shorter board to the longer board and the plywood.

Step 7

Detail of craft boards on plywood

Continue this process by completing each corner with descending widths of wood. We left our wood bare, but you can paint, stain, or finish your artwork however you like.

Step 8

Attach D-ring hangers to the back of the plywood. Be sure the screws are in line with vertical boards to prevent them from poking through the front of the plywood.