Ratings & Reviews for Homax Pro grade 25 Ounce(s) Tinted/white Orange peel Water-based Wall Texture

Clogged up instantly

The can i had clogged up instantly, sprayed everywhere and bubbled out of the sprayer and then came out of the bottom of the plastic shield around the side. At the end of the day it got the job done on ceiling but i think i got more on my arm and hand then the ceiling. Its like the spray device on top of can was faulty or poorly designed. I tried to adjusted it but same issue. The can for the wall worked great with out issue but the ceiling version was horrible to use. I will not buy this produc...

Great for the casual DIYer

If you are like me and only need to texture walls once in a great while, this product is a much better solution than buying your own equipment or renting equipment. I find that my unpracticed hand can get a better result with this product than it can with real texturing equipment. I recommend wiping the nozzle thoroughly after each pause in spraying before resuming, otherwise it is easy to end up with an oversized blob of material on the wall. Also, the instructions say to not exceed 80% cove...

Worthless, horrible, terrible, disastrous, bad

This didn't have enough pressure to reach the ceiling from 18-24 inches away, as recommended, because it basically exploded from every seam and seal when I pulled the trigger. It was at room temperature, shaken for over a minute until I could hear the pea, and it was an absolute mess. Now I have to paint over the collateral spray all over the wall below where I tried to use this, in addition to tracking down a solution that might actually work. Do not even try this stuff out.

Drywall texture match

Great product. Blended into the 20 year old wall, can’t see the repair

Wall texture

I like this product it did a good job of covering the imperfections but I found it very difficult to shake the can and go in a circle at the same time as the instruction say

Easy but expensive

It’s adjustable and applies ok. I just don’t understand why canned texture is so expensive and doesn’t cover nearly as much as it claims. If it’s more than a touch up invest in a texture gun.

Worked as it should..

Never textured a wall before and with this it was very easy! You can control how much and the "thickness" with an easy click of two tabs.

Size adjustment just doesn’t work

The bathroom in my house has texture on the top half and smooth walls on the bottom half, likely from a bad DIY job at some point. I’ve used a similar product before on a another project. The size adjustment on this can just doesn’t work nor does the pressure adjust, or least not a noticeable amount. It just globs our huge specks.. looks really bad.. I will be sanding it all off.. wouldn’t recommend.

How is this still on the market???

I have had 3 of 5 cans malfunction. The valve stuck pen on one causing the panic and comedic response to texture cost my entire bathroom when I only wanted to do a section of the ceiling. Cans 2 and 3 just ruptured at the nozzle creating a foamy stream of texture that runs down the can with little being projected onto the ceiling. It is a nightmare working with this stuff but there is little alternative. I am not ready to purchase a $200 machine and use a compressor to apply 200 square feet o...

Works great!

Sprays nicely, just what I needed for a small drywall repair.

Decent

Hard to match perfectly but this stuff gets as close as possible.