Ratings & Reviews for DEWALT Tube Of 100 No. 20 Size Biscuits

Not usable

The last one i bought, 60 out of 100 were too thick or too thin. The one i just bought 80 out of 100 were too thick or too thin. Completely unusable.

👍

It’s me second batch

They don't go well with gravy

They fit snugly and easily worked into my project

Biscuit thickness was not consistent

Consistency was not good. Some were broken...about 1 out of 20. However, several of the first 20 or so I used were too thick to fit into the jointer holes. This is important because it can cause swelling at the joint of a project you spent many hours working on with very expensive lumber. I have probably used a thousand biscuits in my time and never had consistency this poor.

One in ten too thick for slots

While these biscuits work well when they fit, about one in ten is too thick to fit into the slots cut by my Porter Cable biscuit jointer.

make sure you buy the right size

both products i have been using for years .they are great.

No flavor, but does the job well

I wish they'd offer a gluten-free version.

too fat for the slot

Purchased a container of size 20 biscuits and more than half of them were too wide for the slot. Called DeWalt customer service and they offered that I should go back to Lowe's and get another container. The only problem is that the next container would probably have the same issue. I'm going to my local Rockler store to get biscuits that will fit.

easy to use

easy to for a lot of things

Inconsistent thickness

I can’t believe I’m putting down a DeWalt product, but these biscuits are the worst ones I’ve ever used. Thickness is inconsistent and I’m only able to use 8 out of 10 because many are too thick. Also, several the biscuits chip or split indicating they are not well bonded. Finally, many of them seem “charred”, probably doesn’t affect performance but along with the chipping contribute to a poor overall appearance

To many for the Novelist

Hard to find and I only needed 4. What to do with the 96 I have left over.

Biscuits

Some are too thick and require sanding to fit into biscuit groove.

Excellent

Poor quality control

I bought 100 of these biscuits and 34 of them were useless, too thick to fit the slots. I messaged DeWalt directly through their Facebook page and all they could say was sorry for your inconvenience and we'll pass your concerns on to our quality control department. So basically I'm stuck with 1/3 of the package completely useless. This time I went with another manufacturer.

gravy for biscuits

biscuits for gravy, quality biscuits for wood joinery