Ratings & Reviews for DEWALT 3/4-in 5-7/8-in Black and gold Coated HSS Silver Deming Twist Drill Bit

It's a great product

It works great for what it's used for. Couldn't ask for anything better.

Drill bit

Worked well Don’t forget to oil it if your drilling steal

Did the job!

Needed to drill 3/4" hole through the frame of my truck in 4 areas. This bit held it's edge for the whole project.

Great drill bit

Installed a thermostat on the 1/2” thick lid to my custom bbq pit with this bit.

Great drill bit

Drill bit is tough and gets the job done. Recommend more for a drill press than and hand drill, but still works pretty well with a regular drill.

Use of DeWalt 3/4” of twist drb

The purpose of this bit was to drill 3/4” holes in 2” X 4” to accommodate 3/4” doll rods into the 2” X 4” to use as a drying rack when sesling or

3/4 drill bit for 1/2 in chuck

Can't say I used this! I bought it because I was working late at night and lowes wouldn't be open at that time if I needed it. I bought it just in case. I didn't use it, so I returned it. You know.....when you need it you don't have it, when you have it, you don't need it.

Black Oxide DeWalt bit

Seems to work well on most things. Bought to drill out hole in an old cast iron sink, would barely make a dent in the porcelain.

Expensive for a single project use

Seems to work well as intended. Would have been better with a drill press. My only bitterness comes from the price tag and only needing it for drilling two holes. But seems like a solid product!

steve misner

Wouldn't drill even one (1) hole in a 2 3/8 oilfield pipe

Big bit that works just fine

I used this bit to drill 5 holes through 1/2" aluminum. The 4 holes I drilled with a drill press went quickly. For the last hole, I had to use a cordless drill on a man-lift at an awkward position. Stayed centered without a pilot hole. Much slower at lower speed, as I expected, but it was a great to get the job done.

poor quality

not made very strong, the shaft is cut down to small and bends when the bit gets in a bind

DRILL BIT BORING BUT EFFECTIVE!

What can you say about a drill bit? It bored a hole through 1/4 inch of steel. The resulting hole was the exact dimension that was printed on the package. Can't speak to durability but have faith that the bit will produce similar holes in the future.