Ratings & Reviews for Bosch 3/4-in Carbide-tipped Straight Router Bit

great buy

The bit works better than expected. I am a big fan of Bosch, the quality of their tools never seems to diminish. Bosch bits out prform other router bits I have. I am replacing my other bits as needed with Bosch.

Great cutting

I have had my Craftsman router for 8 years and have got to use it. I restored it put this bit in and it cut like butter. My t track fit perfectly

Replace router bit

I replaced a Diablo router bit with the Bosch. Just as good and a little cheaper. it worked well. I used it to router facia boards for the trim on my house.

Great Bit

I needed this for a bookshelf my son designed. Perfect, sharp & strong. Cut through mdf like butter.

Great bit for plywood dados

I’m reviewing the 1/2” shank 3/4” Bosch carbide dado bit. It is great! Most of my old bits, including the dado bits, were high speed steel. Using this new carbide bit was a great experience. Very clean cutting on the dado shoulders and perfectly flat at the bottom of the cut. Cutting and installing custom plywood shelving in closets - 4 done, two to go. This router bit is a huge help, saving me time because I don’t have any cleanup needed on these sharply cut dados. I recommend this Bosch carbid...

No complaints

Sharp and great for leveling small projects. I use it to plain small boards and projects under 2 square feet with my router sled.

Needed to cut multiple plywood pieces and used this bit to clean up the rough cuts from a template. Worked perfectly.

Bosch straight bit

Cuts clean, no burning. Bosch is my choice for router bits.

Router Bit worked well

This router bit performed just as I expected. It was sharp and there was no scorching.

Great Tool!

I bought this to affix a window sill for above my kitchen sink. The bit is incredibly sharp and made extremely smooth cuts. Would recommend!

Bosch 3/4 inch carbide tipped straight router bit

picked this one up the other day to do repeated cuts for bee frame side bars. Works very smooth, no sanding at all needed. already made over 2000 cuts and still cuts very smooth. just make sure to clean the bits and keep bearing lubricated and should last a long time.

Router bit stays sharp

Cut a couple of dozen slots so far, the blade is still sharp.

It Works...

It spins, it cuts, it didn’t explode... it works!