Ratings & Reviews for Blaster Lubricant 18.0 Ounce(s) Penetrating oils/solvents

prostraw massive pain in the butt.

I am a certified Chrysler technician. 30 years plus. I go through a can of Blaster a week, or at least I did. I recently when into my parts department and received a can with a prostraw. I gave it a try and it was terrible. I can't get it in any tight spots without the straw closing and it is cumbersome. I asked for a can without it and non of the parts stores in town carried them. I am now using other products. I'm disappointed enough to write a review, and not use 50 + cans a year. Which can l...

10X better then wd40

Great Product

I have a can of this my Dad purchased about 30 years ago. I used the same can to loosen up some bolts on a trailer and it worked great. I was surprised because of how old the can is and it still sprayed perfectly.

Difficult to spray.

This Can will not spay continuously. You have to shake it to get it to spray.

Treashed.....TWICE! Never again.....

Absolutely the best penetrating lube on the market WITH THE WORST NOZZLE ON THE MARKET!! The ProStraw is CRAP!! I thought the first time it was my fault but after throwing away my second (ALMOST FULL CAN!) after it ran out of gas, that was proof enough. If I can't get a regular spray nozzle on it, it will rot on your shelf.

Not what I was expecting

I was expecting to use this and it would help release a plumbing pipe, however, it didn’t and it stunk up the bathroom for days afterward

I was disappointed

Used to it take off some metal parts on an electrical panel. Did not work

Don't know of any negative.

Find it works better then WD 40.

It works.

Had an outdoor faucet that needed work. It had a Y adaptor installed on it. Even with wrenchs the agaptor would not break loose. Ran up to Lowe's and got a can of PB Blaster. Sprayed it, waited a few minutes and it came right off. I'll be keeping a can around from now on.

Works!

Use to think WD-40 was the way to go in the start of my mechanical career, but one day I found an old can of PB in the shop, and never went back! Great stuff

Fails to spray

AGAIN I have a almost full can of PB Blaster that fails to spray. I cant tell you how many times this has happened to me with this product.

Great Oil Solvent for Loosing Bolts.

I was replacing a track bar on my 2003 Jeep Wrangler TJ and used the Blaster penetrating oil on the bolts holding it in place. It made it a lot easier when ratcheting them loose. They can be a stinker to brake loose due to rust. Let the Blaster penetrating oil soak a while. In my case I let it set 1 day.

Great product, pro-straw not so much

Why would you mess up a good product with this pro-straw, the pro-straw broke after the third use now a got a leaking mess leaving the can 1/2 full can’t get spray

Works very Well

Is one on the best penetrating oils I have used. When I taught it would break free / loosen most of the hard problems brought to my shop