Ratings & Reviews for NeatHeat 4-ft Hydronic Slip-on Baseboard Heater Front cover

Perfect

Used this to cover an old rusted bathroom baseboard heater. After a couple of snips, it fits perfect and looks great.

Excellent product

I love the way this looks, it is a beautiful heating cover. It was not as easy to cut as I thought, but now that I know I would be better prepared. I would absolutely buy this again.

Quick and easy but check measurements

We like the covers and they are a big improvement. Our radiators are a little deeper than these allow for so slightly distorted in place. Also be sure to measure the length from the top to the lower clip. We should have ordered the longer ones so that the lower clip would engage.

Perfect finishing touch

After installing vinyl beadboard and trim on the ceiling, recaulking the tub, adding a fresh coat of paint and new art on the walls our rusty old baseboard covers were even more of an eyesore than before. I’d seen replacement products in the past, but they were pricey and required removing the current baseboard before installing the new one. Then I happened upon this product during another search. It was the perfect solution...affordable and a quick and easy install over the existing cover. ...

Clean and crisp

I love these covers. They are easy to clean and look great, so much better than those nasty metal covers that rust.

low-cost, easy to install

This product is plastic and a good solution for a bathroom with tight installation space. The end caps were easy to trim to the correct height. I am almost 69 years old and installed the product in minutes.

Expensive

Does what it’s supposed to but expensive for what it is. Not any ofher choices for easy covering though, so this is good if you dont want to completely repace the original baseboard covers.

Make your baseboard look new

Easy to replace your existing metal baseboards. Very refreshing look

Perfect fit

Really spruced up an otherwise unsightly fixture. Not quite as easy as the manufacturer says, but worth the effort.

Great upgrade

Great upgrade replacing my metal covers for this PVC ones. No more rusted cover in the bathroom. Also, they look great!

Beautiful, Easy Install

Excellent replacement for the shoddy, rusty metal (slant fin) baseboard covers. Snap in right over existing cover or you can remove the front plate, if desired. This is what I did. Cuts easy with a coping saw or jigsaw would probably be easier. Photo shows 3 pieces "connected" by two splice plates. The splice plates cover up the gap between the two pieces.

Love the product

Purchased enough to do the whole house. Easy to install, took about an hour to install. No sharp edges. Clean up real nice and easy.

Easy install, looks great

I wish we had purchased these sooner. The steel heater covers in our bathrooms got rusty snd grungy. Samding and painting them was a pain only for them to rust again. These look clean and neat.

Radiator can not be covered

Radiator can not be covered. The product button is less than 3".

NeatHeat covers

Used these NeatHeat plastic covers to coverup rusty tops on my metal floor radiator. Cut to size easily and just snap it right in. Done and done!!

Looks Great

I refinished 4 bedrooms that have baseboard heat. I saw these online and could not believe that it was so easy to install. I got them today, and had them installed in only 10 minutes. The only problem I had was they were about a 1/4" shorter then the metal ones. I took the metal ones off and put the new ones back on and they even looked better without covering the old ones. I looked all over the internet at the prices on these pieces, and Lowes had the lowest price out of everyone. You can'...