Ratings & Reviews for Legrand Corduct 5-ft x 2.5-in PVC Gray Overfloor cord protector

Decent, Once you Flatten it with Heat and Effort.

It does the job, once you modify it. Besides cutting it to length/ the correct angle, the machine that rolls it in the factory puts some sharper-than-necessary bends in it. To see what I mean, look at the product picture at the inner part of the coiled product. That's where you'll have trouble straightening it out. I had to use a heat gun and some repeated effort to make it lie down close to being flat.

basic cord cover

These fit ONE standard cord. If you're trying to cover multiple cords, find a different product. They're pretty basic, and a cat5 or cat6 cable is almost too fat to fit into the channel.

Works great!

This worked great to cover the cords on my carpet. It even comes with double sided tape to stick it to the carpet. My vacuum goes over it just fine.

Very hard material to get flat. It comes in a roll

It will not stay flat to floor

Needs more tape

Works great, make sure to clean the floor before you stick. Biggest issue is that it doesn't come with enough tape. If you mess up and have to reapply, you'll be left with feet of rubber and no way to affix it.

Fit two extension cords well.

This was able to fit two thin extension cords to reach my exercise equipment spread in the room.

Good product

Very difficult to get to lay flat, especially the end that was double folded. It was exactly what I wanted, otherwise.

Works as advertised

As others have reported, this is rolled up and will not lay flat. The hardest part to straighten out was the end that was most tightly wrapped. I put it in front of a space heater for 2 days with a 45 lb weight and the didn't do anything. I What finally worked was to put the end into a pitcher with 2 liters of boiling water for 30 minutes. This properly softened the end up. Then I put a book and 45 lb weight. Done and flat in 30 minutes

Heavy duty; lying flat is a problem.

This is a high quality covering for one or two electrical cords. The major problem is that it comes tightly coiled, and it is very difficult to get it to lie flat. I purchased the exact same thing several years ago, and it still tends to not lie flat. I have the one I just purchased weighed down under bookcases, hoping to straighten it out before I actually use it.

Great quality

Good price. Glad it was heavier duty than expected. Works great where i needed it to.

Works for me

This works for what I need it for. I have some electrical cords under my bed so this will protect them. Yes, I'm glad I bought it. Someone in one of the reviews made the suggestion of using a heat gun on low heat to straighten out the curled ends. Yes, do that! The heat gun trick worked perfectly, just remember to use the LOW setting.

This is useful for more than just extension cords.

I use this to protect the hydraulic lines on my car lift. It works very well

VOCs were bad

The VOCs coming off of this were horrible. It wouldn't stick to a clean floor for a second. Regardless of that I gave up on because the smell was so bad which is super concerning with all the cancer warnings all over the instructions. Horrible.