Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

E-Z Mender 28-in x 28-in Powder Coating, Black Steel Post support For Wood Fence

Questions & Answers for Simpson Strong-Tie E-Z Mender 28-in x 28-in Powder Coating, Black Steel Post support For Wood Fence

4.6
263
See Product Details
16 Questions
16 Questions
Can these be used on a vinyl gate post that is wobbly?


Can these be used on metal fence posts too?


Can you install a vinyl post cover over top of the mender once it is attached to the 4x4?


Should screws be installed at an angle or straight in? Or should it be a mixed batch?


What sort / brand of screw should I use? The screws pictured above do not fit the VERY tiny holes. I have no compressor.


Do you make them for 6 inch post?


Will this work on a round post? Or only the square 4x4?


How would this product work if the concrete is flush with the ground?


I have a good post but it was put in off kilter ed. Would putting one of these on one side straighten it out so the post would be level?


Can I use this for the same purpose but with a 2x3 piece of lumber?


I have rough sawn 4" posts so they are true 4". Do these work for that case?


Will this prevent hinge side post from "leaning" causing unaligned latching for a 5' w x 6' h wood gate?


Should the EZ Menders face outwards (towards the property) or inwards (under the rails) on both sides of the posts? I've seen video's that show both.


is it necessary to dig out the dirt around the post (as shown in the diagram) before hammering in the fence mender?


What is the length?


How do these work?