Hi, Could you give me the steps how to clean this filter? I understand, I don't need to remove it to clean it. Thank you.

OJCapri, Cleaning Instructions - Flushing the Sediment 1. The primary method of removing sediment from the system is by flushing separated solids through the flush valve while the filter is under system pressure. 2. Open the flush valve (F) for 15-30 seconds while system is under pressure from the pump or tank. For irrigation systems without pressure tanks: Open the flush valve Make sure sprinkler valves are turned off Turn the pump on for 15-30 seconds. This will flush out the filter screen. NOTE: To avoid water-hammer, always close the flush valve slowly. 1. The filter screen (C) may need to be removed for cleaning. To remove the filter screen, turn off the water supply, drain water from the system, unscrew the filter bowl (E), and remove the filter screen (C). Wash off collected sediment from the screen with warm water. Remove fine particles wedged in the screen by brushing with a soft brush. Apply silicone grease (DOW 111) to O-rings (B and D) if needed. Reassemble filter screen, bowl, and cap O-ring after cleaning. HAND TIGHTEN ONLY (Use of tools will void warranty). If you hav e any questions, please call our tech support team @ 1-800-742-5044. Thank you.