Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

15.75-in Center Mount Zinc Drawer Slide 35-lb Load Capacity

Questions & Answers for Richelieu 15.75-in Center Mount Zinc Drawer Slide 35-lb Load Capacity

3.5
188
See Product Details
32 Questions
32 Questions
Does the slide come apart? Also, I'd like to find some instructions on installation before i buy. Have looked, but can't find anything.


Center Mount Slide Richelleu 16" T35072G16


once the slide is mounted to the drawer and closed how do you remove the drawer


Does the slide come apart so each side can be screwed properly to the drawer and the dresser?


The website given in the answer is the same as on the packaging and does not show how to separate the bracket. How do you separate the two brackets?


How do you release to get the drawer out


Would this fit a 20 inch long drawer with a cabinet depth of 23 3/4 inches?


Is this a side mount or under mount?


What is the weight Capacity of each


My drawer is 15 1/5" & the opening depth is 20 1/4". I can't find a sizing guide. Which center mount drawer slide would be the correct one to use?


I have a drawer length of 18 3/4" and a cabinet depth of 19 1/2". Will either slide work?


I have 17.5 depth can the slide be cut to length


Are these adjustable for up to 17 inch deep cabinet? It looks like the rear bracket will slide out allowing a longer than 16 inch depth.


Can it be cut down


My existing drawer slide is 14" (part attached to the drawer) and 16"(part attached to back of the dresser. Will this work for me?


How to connect the rear bracket to the slide? When fully extended, the tab on the rear bracket keeps coming out of the slot in the bottom slide.


How thick is the hardware? I want to make sure I have enough clearance under the drawer.


I have 6 drawers and i need the center piece for the drawers. The length of exusting metal bar is 14 inches. Will this 16 inch fut


Can the 16" length be trimmed down to 13.25" to fit the depth (front to rear) of my drawer?


I have a dresser drawer that is 21" wide and 14" deep which needs a new center slide. Will this work and handle this size drawer?"