Where precision meets durability with every strike, the 12-Piece punch and chisel set is built to handle challenging tasks. This set includes two taper punches, two center punches, three cold chisels and 5 pin punches. Perfect set for any demanding job, these tools ensure reliable and quality performance. The octagonal shape is easier to grip when striking with a hammer and also prevents the tool from rolling away when placed on a surface. The material core design prevents mushrooming of the striking head. Tools are tempered to a hardness of 54 to 58 HRC - not just at the tip but throughout the entire length of the tool. Compiles with DIN 7255 standard. Taper Punch - 9R 440 003 KUS (7/64" x 4 3/4") and 9R 440 006 KUS (15/64" x 4 3/4"). Taper punch helps align holes in parts for easier alignment of bolts; A taper punch can be used to loosen rusted or corroded parts. Cold Chisels - 9R 360 202 KUS (3/8" x 8"), 9R 361 202 KUS (1/2" x 8) and 9R 362 202 KUS (9/16" x 8"). Chisel features a hand ground sharpened edge designed to cut and shear cold metal; Striking head is turned and chamfered. Center Punches - 9R 431 120 KUS (3/16" x 4 3/4") and 9R 434 150 KUS (15/64" x 6"). For exact marking of a drill point and guidance of the drill bit; Center punches are used to create permanent marks or locations when disassembling engine parts. Pin Punches - 9R 453 101 KUS (3/32" x 6"), 9R 453 102 KUS (7/64" x 6"), 9R 453 103 KUS (11/64" x 6"), 9R 453 104 KUS (5/16" x 6") and 9R 453 105 KUS (25/64" x 6"). Pin punches are used to install and drive pins out of holes; All edges are rounded to prevent damage to the workpiece. RENNSTEIG is a member of the KNIPEX Group that specializes in the design and manufacturing of high quality tools.
Where precision meets durability with every strike, the 12-Piece punch and chisel set is built to handle challenging tasks.
The octagonal shape is easier to grip when striking with a hammer and also prevents the tool from rolling away when placed on a surface
The material core design prevents mushrooming of the striking head
Tools are tempered to a hardness of 54 to 58 HRC - not just at the tip but throughout the entire length of the tool
Compiles with DIN 7255 standard
Taper punch helps align holes in parts for easier alignment of bolts; A taper punch can be used to loosen rusted or corroded parts
Chisel features a hand ground sharpened edge designed to cut and shear cold metal; Striking head is turned and chamfered
Center punches for exact marking of a drill point and guidance of the drill bit; Center punches are used to create permanent marks or locations when disassembling engine parts
Pin punches are used to install and drive pins out of holes; All edges are rounded to prevent damage to the workpiece
