This is a painted diecast inside lock with heavy-duty steel spring bolt. The key cylinder has aluminum face and 5 pin tumbler lock with cylinder ring, and will replace most locking mechanisms of this type. The spring will put the deadbolt back into place unless the knob is turned 180 degrees and then it holds it in place. Make sure to test fit the lock and make sure the key turns. If the key does not turn you will need to trim the tailpiece of the lock.
Used by a variety of garage door manufacturers
Heavy duty spring bolt
Center mount design
Diecast construction with an aluminum finish
5 pin tumbler
Mounting hardware included
The tailpiece may need to be trimmed for the lock to fit your specific door
Please refer to the line art drawing for dimensions and compare with your needs before ordering