For use with electric baseboards, convectors and fan forced heaters, the CT410A non-programmable thermostat is a practical option. It’s rugged, yet simple to install and economical in use. Use this option to replace virtually any two-wire line voltage wall-mounted electric heating thermostat.
Can be used to control a single electric baseboard heater, or can be used to control two or more electric heaters provided the combined load does not exceed 5280 W (no minimum load required)
Temperature control is boosted with a dual diaphragm bimetal sensor that actively senses temperature
Easy to use: basic design keeps operation simple
Electric heat only (2-wires)
Mercury-free
Includes mounting hardware for simple installation
COMPATIBLE WITH: Line volt heating only (120/240V) including electric baseboards, convectors and fan-forced heaters (Power: 2640W at 120 Vac, 22A resistive; 5280W at 240 Vac, 22A resistive; 5263W at 277 Vac, 19A resistive)