DRYLOK Pro Off-white Flat Solid Latex Mildew Resistant Mold Resistant Interior/Exterior Waterproofer ( 5-gallon )

Excellent product for covering interior concrete

Bought this product to coat concrete basement wall before finishing. Took 2 coats to cover properly but works well. Goes on a little thick though so figure on using more than you would just paint.

Seals great - Pro is also anti-mold

I like that it is such a solid seal for concrete clock in wet & damp environments

I'm locked in... To this product

So easy to paint, Great coverage, really does a good job of changing the humidity level in a basement

Easy to apply

We spent a few hours scraping, wire brushing, etching, rinsing and wiping down the basement block walls before we started, especially the lower 2-3 block where our water problems have been seen over the years. Cracks and holes were filled and allowed to set overnight. We spent about as much time prepping as we did applying the paint. We used very heavy nap rollers on poles to apply the paint, working it in with a lot of rolling, and back brushed joints and areas that needed a little extra atte...

So far had kept basement dry.

Works great, goes on easy and had several colors to choose from.

Disappointed

There were a lot of clumps in the paint. Almost like some had dried to the lid and when it was shaken up it peeled off and was mixed in the paint. Not a huge deal but kept having to scrape off the spots after rolling to remove the dried pieces.

Game Changer to lighten up the cellar walls

Painting cement-block walls that have never been treated. Light, pleasant odor, water-based, easy clean-up.

Multiple layers will yield the best looking result

Used this to finish my basement. Applied smooth and had a nice finish.

Worth every penny

Great coverage applies nice smooth finish really brightens up a basement!

Did not work. Removes with fingers.

I applied the drylok to bare masonry, foundation walls- not concrete. The walls were prepped using a grinding wheel. My home is nearly 100 years old. I rolled the application per the specs and brushed several areas as well. I rolled a second coat and covered any remaining pin holes. After 2 weeks and after applying paint, several areas bubbled. I can remove the drylok easily with a finger nail and a putty knife.