The DRICORE™ PRO Concrete Repair system has been specifically designed and engineered to seal, fill and structurally reinforce concrete cracks. This 3-step system includes: step 1-crack prep surface paste, step 2-crack injection expanding foam and step 3-the carbon fiber reinforcement kit.
Each kit will fix approximately one wall crack that measures 4-5 feet long, 1/16 to 1/8 inches wide and 8 inches deep (121-152 cm long, 0.15 to 0.31 cm wide and 20 cm deep), may vary from crack to crack
This kit combines step 1 and 2 of a 3-step approach to concrete repair (also includes injection ports)
Advanced, fast-acting, moisture-resistant polyurethane formula expands 15x its volume to completely fill cracks in concrete
Low-viscosity, easy-to-inject foam is ideal for vertical wet or dry crack repairs through injection ports
Interior and exterior applications; only use injection for cracks in poured concrete walls - we do not recommend injecting into concrete block (CMU) walls, as their hollow structure requires a different repair method
Use the included epoxy with a 10:1 thrust ratio caulking gun (sold separately)
The injection material is yellow and viscous while injected before curing
Injecting concrete cracks DOES NOT prevent the crack from re-cracking, only the DRICORE Carbon Fiber Reinforcement Kit will prevent re-cracking
The tube is designed to mix two separate solutions during dispensing, thus due to the internal mechanisms, the plunger will only advance to the middle of the tube (the quantity stated on the label is correct)