Ratings & Reviews for TotalBoat 2 -Pack 1.5 Quart(s) Clear Wood stabilizer

Penetrating Epoxy

Works very well for damaged/weathered wood. This soaks into the wood and prevents further weather damage. The only drawback is that it needs to be sanded or washed to remove the amine blush after it has cured so primers will bond to it.

Penetrating Epoxy sealer works quite well.

Fantastic! I was able to salvage seriously deteriorated lumber & restore to initial functionality. Syringe works well on horizontal surface....not so much on vertical. Brushes waste less material.

Inlays with epoxy

Works great to keep epoxy inlays from bleeding into the wood grain

A Wood-Rescue Epoxy I've Relied On for Years

I've used TotalBoat penetrating epoxy for years, so when a leak left some wall framing soft and punky, this is what I reached for instead of cutting the wood out. The penetrating epoxy is a true two-part solids epoxy: it wicks deep into damaged wood, cures hard, and turns spongy fiber back into something solid and sealed against moisture. The included syringes let you inject it into voids and end grain, and a small amount of acetone thins it for deeper penetration when a spot needs it. For mater...

very far reaching

Very easy to use and spread. A thin layer goes a long way. I found the pumps the best way to measure. Use it in small batches to go a long way. Easy mix and mixes well

Penetrating Epoxy in a Monterey Wood Boat.

In 1998 I owned a rare 40ft Monterey Double ended Commercial Fishing Vessel . There was a Grounding Rod in my Rudder Block of the Vessel. It was built in 1918. So over the years it had turned to mush. I drove to Richmond to his facility. Talked to him and purchased Part A and Part B 5 gal each or the Penetrating epoxy. I planned to use it all over the boat. He told me to mix equal parts A and B wait a bit then I started pouring and mixing it. i had made a trough in the Keel Rudder Block which wa...

Penetrating

I like this product to thin and stabilize wood before epoxy pours

Easy application

We used this protect the floor of an old pontoon boat. It was easy to use and went on quickly using a paint roller.

Great for Stabilizing Wood

Perfect for filling small holes, cracks, or sealing live edge before a pour. Takes dye easily.

So-so Results

Epoxy (cold weather variety) was mixed according to directions and applied at 55F to plywood as instructed. Two coats applied to surfaces with three coats on the edges. It didn’t seem that the epoxy penetrated very much- it mostly just sat on the surface until it cured. It will work for my purposes, but the result was not what I expected. Not sure if the problem was the product or some unknown user error…..

Penetrating epoxy sealer

The epoxy was easy to apply and will provide excellent water protection on my boat trailer bunk boards.

Fantastic stuff

This is an amazing product, easy to mix and easy to use. Totally encapsulated the wood I used it on to a beautiful gloss finish( which I had to rough up for the next step. Getting ready to order another gallon