Ratings & Reviews for Kobalt 10-in 15 -Amp 120 -Volt Portable Jobsite Table Saw with Gravity Rise Stand

Definitely worth the price

Directions to put together are a LITTLE difficult but fairly straightforward to assemble. Great saw to work with.

Switch is garbage

Bought this saw March 24. Used it to cut and install vinyl plank flooring until the power switch would no longer operate without holding down the button. Swapped the saw out for a new one and a week later had the same problem after light usage. I called the help number and all they can do is let me take this 100 lb table saw back to the store, again, and then get and assemble a 3rd saw. All I need is a working switch, but apparently that’s too much to ask. The saw works great, but it’s not safe ...

It works good but a bit big

Works good

Maintenance

After the first year of light use you can't raise the blade. Found videos that tell you if you want raise the blade use pliers to pull up on the kerf knife while turning the wheel

Be Gentle, It's my First Time.

This is my choice for my first table saw. I picked this saw because of the stand and the rip capacity. I went with the stand because it is mobile. I have limited space and being able to move the saw to where I need it easily makes all the difference. The rip capacity is awesome.

first saw arrived damaged, on the second saw

Table saw runs but have not had a chance to perform cuts on it.....still building a table for it

Nice saw and would buy it again

There's a lot to like. Starting with the ability to fold it and roll it out of my way when I am finished. I really like the pinion adjustment for the fence, and the small tray that helps hold wider material. The only real annoyance was the poor picture that shows how to put the folding table legs together. It wasn't clear which one was on which side during assembly. I wound up taking the leg's back off and trial and errored it until it worked. Overall a one-time minor nuisance.

Homeowner yes, commercial?

For my use, homeowner, it does the job. The assembly time for this project 2 hours. laying out everything helps figure out the really BAD instructions. The illustration quality and size are challenging. There is a lot of plastic involved here too.

Better than you think.

Once set up squared the saw has worked much better than I expected. The cuts are easy and I get finish cuts after installing a different blade. The only headache I've had was assembling the stand. Some of the diagrams were a bit confusing. The stand once assembled is great. Setting the saw up to use is effortless as is taking it down. Over all I believe I got the right saw for the work I will be doing.

Must purchase

Exactly as described

ok

good for the money

Good for the price

I bought Kobalt instead of Dewalt due to the price and I'm only a weekend woodworker. It has all the features I liked. Cuts good, plenty of power, fence is good, but very loud! The prongs on the cord broke. Called Kobalt and couldn't get a new cord. Had to swap for new one at Lowe's.

Great saw for the money

This saw was setup true out of box no adjustments were necessary. The assembly instructions were not very clear but the pictures helped a lot but assembly was not difficult.

Nice saw

It makes good clean cuts and will cut up to 32.5” cut

It wasn't too difficult to set up and works great.

So far it has been fantastic.