Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

15 -Amps 120-volt Indoor Countdown Digital Lighting Timer

TORK 15 -Amps 120-volt Indoor Countdown Digital Lighting Timer

4.6
97
See Product Details
24 Questions
Read All Questions & Answers

how to install this switch


R5M4HW IN-WALL DIGITAL COUNTDOWN TIMER We recommend that installation be made by a licensed electrician. Disconnect power at main panel prior to installing or servicing this time switch or the equipment connected to it. Connect in accordance with national and local electrical codes. CAUTION: For your safety: Connecting a proper ground to the timer switch provides protection against electrical shock in the event of certain fault conditions. OPERATION This preset timer has two program sections: Option 1- indicator light OFF (default) Turn ON the connected light or fan by pressing the desired time button, or the ON/OFF button. If you press the desired time button, its indicator light flashes twice to show the new countdown interval is set. If you press the ON/OFF button, its indicator light flashes twice to show that the last used time selection was activated. When the set time is out, the indicator light under the ON/OFF will also flash twice. Option 2- indicator light ON Step 1: To change program from the factory preset mode (Option 1) so that the indicator light for the selected preset time button stays on for the duration of the time period, simply press and hold the top 2 buttons (5 min and 10 min) simultaneously. All indicator lights will flash once indicating program has been switched. Step 2: In this mode, when a preset time button or the ON/OFF button is pressed, the selected preset time button will remain illuminated for the duration. Step 3: To switch back to Option 1 mode, simply repeat above steps. Note: In the case of a power failure, the Preset Time Switch will switch back to the factory setting mode (Option 1). Manual OFF While a timer is active, you can press the ON/OFF button to turn OFF the connected light or fan immediately. Hold Mode(Continuous Operation) To turn timer On for extended periods of time, press and hold the push button for more than 8 seconds. Timer enters HOLD mode, the connected load is turned ON. To exit HOLD mode, press any button of the timer to turn OFF the connected load.

Was this Answer Helpful ?