how does this work....attach??

Thank you for your inquiry regarding this item from Prime-Line. This item would just peel off the backing paper and stick to screen fabric. You can contact the manufacturer directly with your questions regarding this item, or any other product manufactured by Prime-Line Products by calling their toll free number at (877) 649-9740, or by contacting them by email at info@primeline.net.

It fits over the hole--make sure you have the correct size patch. then you push the wires through and crimp them down easy and quick.

Unless your fist is less that 2" - no way will it repair - it is only 3" square

It is adhesive. Remove the back sticker and press it on.

If your hole is fist sized, replace the screen. This is for small holes, about 3"x3". It attaches by sticking to screen over the patch.

This product is a strong clear adhesive with screen patterning on it. A fist sized hole is probably a little large for this product to effectivley cover.

Comes with backing you pull off to reveal sticky side. Just cut to size prior to pulling of backing and press on screen over hole. Keep in mind this is only 3''x3'' patch. Will it cover your hole? Not sure how it would look if you had to overlap them... ??

The patches are sticky on the side that faces the screen. You just peel of backing and place on screen and you're done. These patches are only 3x3 though so I'm not sure it would cover your hole. Not sure how it would look to overlap them. I might just replace the whole screen if I were you.

The material has a peel off adhesive side and once applied you should use a hard rolling to press it down or the rounded end of a plastic tool

one side has adhesive and sticks to the screen. I would not try to cover a large hole with it. I think a fist size would be too much for this to try and cover