Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

2-ft x 2-ft Adjustable Lumens Switchable white LED Panel Light

Lithonia Lighting 2-ft x 2-ft Adjustable Lumens Switchable white LED Panel Light

4.6
107
See Product Details
10 Questions
Read All Questions & Answers

I have three of these fixtures in a series. Can I dim these down? Do I need to go to low-voltage?


Have dimming leads? My two DO NOT.. "CPX with NEW SensorSwitch JOT!" - try to find a JOT dimming switch.

Was this Answer Helpful ?

The CPX uses 0-10v low voltage dimming. There will be a set of purple and gray wires which extend from the driver inside the fixture. This is a 0-10V dimming circuit. You will need to run a low voltage wire (typically 18 gauge) from these wires to a 0-10V dimming switch. You can install the wiring from the dimmer switch to the first fixture, then to next, etc. (in a daisy chain fashion). You do not need to homerun each wire. The dimmer switch will also have an input to switch the 120-277V as well as the low voltage inputs for the 0-10V dimming circuit. This will ensure you can turn the fixture off as it will only dim down to 1% or 10%.

Was this Answer Helpful ?