What is the biggest bit this router will accept
5
My router will only accept 1/4" bits. I did see that later that router accepted both 1/4 and 1/2
Was this Answer Helpful ?This can be used with either the standard 1/4" or a 1/2" collet. As for the size of the actual bit, I imagine you could get just about anything in there; there are adjustable rings to increase the size of the aperture in the table for the bit to protrude. Hope this helps.
Was this Answer Helpful ?the manual says nothing bigger than 1 1/4" diameter, or it will not fit into the sub-base and/or possibly damage it.
Was this Answer Helpful ?I think you might be surprised. This router is identical to a certain C-man from another well known retailer, in every detail. Same housing, base, adjustments and all. I'd even bet that if you don't like the 1/4 inch insert, that you could order a separate 1/4 inch collet for a C-man to fit this. Also, the bit shank size has nothing to do with the tool holding up to use it. It is the overall size of the cutter head vs. the HP of the router that determines that. Many of the same common bits are available in both 1/4 and 1/2 inch shanks, with 1/2 inch shank bits benefitting from less vibration, leaving less chatter marks on your cuts. Some large bits are only available in 1/2 inch shanks because of their size. These larger bits must be used at lower RPMs. A good rule of thumb to follow on routers of less than 2HP is not to use bits larger in cutter diameter than one inch. Even on routers of 2HP and up, a variable speed control is needed to use the largest bits such as rail and stile or panel raising bits. This router is only a single speed model. In my opinion, its best use would be with bits for edge forming or shallow grooves and dadoes.
Was this Answer Helpful ?It has a 1/2" collet, but, we don't believe the tool will hold up using anything in that range, unless it is just for skim cuts.
Was this Answer Helpful ?