Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

1/4-in 1.75-HP Variable Speed Plunge Corded Router with Table

Blue Hawk 1/4-in 1.75-HP Variable Speed Plunge Corded Router with Table

2.8
49
See Product Details
12 Questions
Read All Questions & Answers

Router bits


It is a 1/4in shank. You might be able to find an aftermarket collet to accept 1/2 in.

Was this Answer Helpful ?

it only uses 1/4. It Cannot use 1/2, no matter how hard you try or how bad you want it, this router will NOT do it

Was this Answer Helpful ?

1/4" with the collar it comes with

Was this Answer Helpful ?

I would only use 1/4" shank bits. 1/2" shakes the router alot more, the table my not support that much movement since it is small.

Was this Answer Helpful ?

Use only 1/4 inch bits. This router is not made to handle larger bits.

Was this Answer Helpful ?

You can only use the 1/4" bits. I have used this router on many different type of wood and not had a problem.

Was this Answer Helpful ?

It uses 1/4" bits only.

Was this Answer Helpful ?

This router comes with a 1/4" collar so you will need 1/4" shank bits

Was this Answer Helpful ?