Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.

3/4-in x 3/4-in Barbed Barb X Mip Adapter Fitting

Questions & Answers for ProLine Series 3/4-in x 3/4-in Barbed Barb X Mip Adapter Fitting

4.6
148
See Product Details
20 Questions
20 Questions
what is the inside diameter of the barbed section?


Why don't you specify which end is threaded, end 1 or end 2? Is the the thread 1/4 or 3/8? Is the barb 1/4 or 3/8?


Is it 1/8npt?


Is this 1/8” npt?


Thank you for your quick response earlier. How long is the Barbed end? I plan to use two hose clamps 3/8" wide each. Is the barbed end long enough?


Is this barbed end long enough for use with Polypropylene. The fitting I am replacing takes two hose clamps.


Is this safe for potable drinking water?


What is the thread pitch?


What is the thread per inch on this


I like to know if the threads are 1/4 od and same goes for the barb side because I have a HHS drill tap bit 1/4-20 and got 1/4 hose on my boost bottle


Is the thread portion 1/8inch?


Will 5/8” barbed fitting fit into 3/4” hose?


HOW DO I FIND THE LOCATION OF THIS ITEM IN THE STORE? IT SHOULD BE EASILY MENTIONED ON THE SITE SO I CAN WALK IN AND FIND IT, AM I MISSING SOMETHING?


Is this good for fuel


What size is the MIP?


What size vinyl tubing would fit onto the barbs?


does this have a 1/418 NPT pipe thread or NPS


does this fit 1/2 160 psi polyethylene pipe?


Is the threaded end 1/8?


What size tap bit and hose would I need for this fitting?