The 11-513-104 is a one input to four output composite video distribution amplifier with a single ended input 75 Ohm termination. This unit has a single gain pot controls the gain of all four outputs. Unused outputs do not need to be terminated with 75 Ohms. All of the video connections are BNC connectors. This unit is intended to be used with NTSC or PAL video signals.The common application of this unit is to generate four copies of a single composite video signal so several downstream devices can be driven without degradation of the video quality. Because this is an active device requires power signal quality as well as signal levels are maintained while generating the multiple copies of the original signal. The high bandwidth of this unit insures the input video signal is not modified due to bandwidth roll off DC - 200 MHz bandwidth at -3db level.This unit has a non-isolated internal switcher power supply FlexPWR. The unit will operate correctly on 10-28 VAC or 10-32 VDC. The power input is protected so power can be applied in either polarity. The supply provides the internal electronics with power with the ground of the video circuits being the same as the input power ground. The power connector is a 2-pin 2.5mm terminal block with detent retention that can support high vibration environments. FeaturesAnalog video distribution amplifierNTSC or PAL formats1 input, 4 output configurationSingle gain control for all outputsStandard single ended 75 Ohm terminated inputBNC connectors for video signalsSealed epoxy pack2 pin 2.5mm terminal block power connectorMounted using two 6-32 threaded inserts
