Paslode 3-1/4-in x 0.131-in 21 -Degree 12d Bright Smooth Shank Collated Framing nails Box

Good 21 degree nails

These passlode 21 degree nails worked great with my Milwaukee air nailer. They seem to hold very well and never had a misfeed. They seem to be well made and definitely worked well.

Nice long 21 degree nails

These are long framing nails. They can nail 3 2x4’s together with ease. It did require turning up the pressure. The best thing I like is no broken sets of nails. I’ve had issues with other brands that the the material holding them together would break while loaded in the nail gun which caused jams.

These nails drive well

There were a few loose nails in the box because the box was damaged in shipping. These nails load ,shoot and hold great. I used them to frame my pump house. They were shot out of a Metabo gun with no jams or other issues. I will definitely use again.

These nails really stick

Nails - what can you say - hit them and they stay put! These 3-1/4" nails have a nice epoxy coating on the end, which allows for additional grip strength once they have been set and put in place. Makes for a nice tight connection. MInimal plastic used to keep the strips together means less mess of plastic all around the job site. On the down site, the packaging of the nails was pretty loose, increasing the possibility of breakage in shipping or transporting to the job site. Also, not sure w...

Great improvement over competition

The Paslode 3 1/4 framing nails are a great improvement over other models. You can use these without fear of getting hit by fragments of the plastic strip as these do not have them. These fit in a harbor freight nail gun and work perfectly with zero jams! I am currently using these for my framing project and I am very pleased. There are no broken collated strips to worry about either. Would recommend!

A solid choice for nails

I used these nails for a renovation of an old 80 year old house that requires a lot of new and replacement framing. I have two framing nailers, a Hitachi (now Metabo) nailer and a DeWalt. Paslode advertises on the box that they are the best nails for Hitachi specifically, but I found that they worked flawlessly in both nailers. I don't have anything bad at all to say about these nails. I used both sequential and bump nailing to check these nails out, and had no issues. Based on my exper...

Decent framing nails

I have found that these nails feed well from my Hitachi NR83A. The plastic collation is softer than most I have used which limits how much debris gets sent flying. The nail strips are longer than the Hitachi that I typically use, so from a full empty, I can’t load two new strips. This is kind of aggravating but just takes a change of mind set to put in an additional strip before you hit empty. The vinyl coating seems thin, but seems to still hold reasonable well. I will likely end up using these...

Quality framing gun Nails.

So these 3 1/4" x 131" interior Framing nails are excellent in the fact that they flex but don't snap in half,2000 nails is a perfect amount most of the time.With Paslode you can never go wrong

3 1/4" Framing Nails

Paslode 21 degree plastic collated framing nails come in strips of 35 and are collated with 2 thin clear plastic strips. They are a full round head nail. I find that there is less plastic debris from these than other brands. They work very well and I have not experienced a jam yet even with the last nail.

Nice Nails

The nails are very well made and are used in a large variety of nail guns. They are indoor use only so don’t get them mixed up with outdoor nails which are best suited for treated lumber.