The Leprecon APC-3P ACP Series (Architectural Panel Control) system is designed to provide a solution for integrating architectural and theatrical lighting control into a single DMX-based system. The APC panels incorporate a clean, low profile design that will blend into any environment. APC components are easy to install, wire and configure. When used with Leprecon APC wall panels, the APC Hub provides a complete solution for integrating panels with a DMX system. The Hub provides DC Power, DMX in and out, and connections to the installed APC panels. APC Hub uses 5 pin XLR connectors as required by the DMX standard for data connections. The output from the Hub to the DMX dimming and fixtures is isolated and buffered. FeaturesDirect DMX outputUp to 12 programmable scenes of 512 channelsPanels can be disabled when console is in useSimple interconnect using CAT5 cablingProgrammable fade time for each presetSingle programmable blackout fade timeProvides DC power for up to 10 APC panelsProvides isolation and buffering from the console and panel controlsStrips alternate start codes from the data stream before sending it to the systemRe-time the DMX signal for best compatibility with non-compliant devicesSpecificationsDimension: 8.12'' x 1.90'' x 4.87''Weight: 1 lbs
