Kobalt CTM10P 10-in Wet Continuous Rim Diamond Saw Blade

Clean cuts

The cuts are clean and my edges look better than the factory cuts. This is an enormous upgrade to the blades that come with the standard saws. Clean cuts.

Core plate rivet failure causing separation.

DO NOT BUY!! NO WARRANTY! Blade cuts greate but fabrication quality is poor. The core plates that reinforce the blade from flexing separated from the blade. The rivets failed. This is an obvious manufacturing fabrication failure but Kobalt will not replace without warranty. Local store said to call Kobalt. Kobalt said to to to store. Blade is less then 12 months old and the mesh cutting surface shows little wear.

Not for cutting anything thicker than 2 inches

Bought this to cut rocks, thought that a 10 inch blade should cut some thicker pieces but the reinforced center sticks out and catches/stops the rocks. Have to rotate and end up with an uneven cut edge. Should be able to push straight through! Why would I pay the money for a 10 inch blade to only be able to use 2 inches of the blade? Terrible design!

Blade sucks

I got to use the blade for one shower. Blade would cut slow and took forever. I can’t afford to spend 70 per shower on a diamond blade. A lot better blades out there. A lot better

Strong saw blade

Can't get full cut use of the blade because of the extra ring of metal. Can only cut about 2" thick

So smooth

Great blade for cutting porcelain tile like butter