Etokfoks Two Point Bolt Mortise Lock For Pella Storm Doors With 2 5 In Handle PZ 7 8 In Backset And 7 1 4 In Faceplate Screw Hole Spacing

Specialized two point bolt mortise lock is designed to fit select Pella storm doors only so you should carefully compare measurements and layout to your existing hardware before purchase to ensure proper alignment and secure fit

Bolt spacing is 2 5 in apart with a centered deadlatch and a handle PZ of 2 5 in from cylinder center to handle center offering a precise match for compatible Pella storm doors that use this specific locking configuration

Faceplate screw holes are spaced at 7 1 4 in and matching screws are included to simplify installation so you can mount the replacement mortise lock securely into the storm door edge without needing additional fasteners

You should keep your original storm door hardware available during installation because certain parts or reference positions may be needed to align the new mortise lock properly and to complete a smooth hardware replacement process

Four spring loaded tabs help hold the mortise lock firmly in the storm door panel even when faceplate screws are removed and you can retract these tabs using a small pry bar or stiff putty knife during removal or adjustment

To remove the keyed cylinder you first take out the cylinder screw then turn the thumb turn slowly and pull when the cam is aligned so the cylinder comes out smoothly allowing service or replacement without damaging components