BORA 3-Pack 100-in Ngx Bar Clamp

It’s never been easier to rip, cut, and break down material than with the NGX clamp edge system. No more fumbling with adjustable clamp ends on opposite sides of the straight edge — the adjustable clamp is connected to the handle. Simply hook the clamp edge across your board, line it up with your cut, and clamp it down — all without moving your feet. No matter how accurate your cuts are, ugly tear-out can still happen. End tear-out for good with the NGX saw plate, specifically designed as part of the Bora NGX clamp edge system. With its easy-to-use, intuitive design, you can mount your saw and rip a board in no time. An especially helpful feature of the saw plate is the non-chip strip, which saves your boards from tear-out. Simply press this self-adhesive strip onto the clamp edge and cut—this trims down the excess width of the strip so the edge of the non-chip strip sits flat against your blade. For every future use, just line up the strip to your measuring mark for accurate, clean results.