Squids Slips are perfect retrofit tool attachments for small hand tools to help reduce the risk of dropped objects and increase workplace safety. Connection points for tool lanyards can be tricky to find, especially on smaller hand tools like screw drivers and hex keys (Allen wrenches). While working at-heights, it is important to tether tools as part of your overall fall protection plan, but the lack of these connection points can make that difficult. Small hand tools have always been challenging to connect tool lanyards to. Screw drivers, small combination wrenches, punches, hex (Allen) wrenches and the like do not have captive connection points, and the low-profile designs can make it difficult for tapes, shrinks and tails to be applied. The Squids Hand Tool Slips allow you to tether tools up to 1lb based on their diameter. Four sizes of Slips are compatible on tools with diameters ranging from 0.05 (1.3mm) to 0.5 (12.5mm).
Approved to the ANSI/ISEA 121-2018 standard
Patent-pending one-piece design easily slides onto small hand tools without requiring additional tools to install or complicated wrapping or shrinking to apply
Swiveling exterior ring spins 360-degrees allowing screwdrivers and other rotating tools to be used without issue
ABS outer ring provides strength and durability in all environments, testing in hot, cold and wet conditions
Flexible inner core grips tool after application securing it as an attachment point for a tool lanyard preventing dropped objects
Available in four sizes compatible with tools ranging from 0.05andrdquo; (1.3mm) to andfrac12;andrdquo; (12.5mm)
Maximum tethering capacity up to 1lb (0.45kg) dependent on size (review size chart for capacity information)
Intended for singled use, discard after removal and replace
Patent Pending Design
