Tools and Materials
Tools
- Measuring tape
- Screwdriver
- Shovel
- Scissors
- Laser level
Spirit level
Shovel
Spear
- Rake
- Drill machine
- Pipe
- Pool water filter
- Sand filter
How to Set up an Above Ground Pool
Consult your local building codes or homeowner’s association before beginning the pool installation above ground. In some areas it is necessary to get a permit for an above ground pool setup. Once this has been sorted out, follow these steps explaining how to install an above ground pool.
Measure your above ground pool and your available space using a measuring tape. It will help you decide where to install the pool. Finalize a flat surface with ample sunlight.
Make sure that the pool is at least 6 feet away from any slope. Use a laser level to check if the surface is flat.
An above ground pool can overturn if installed over an unlevelled surface. Select a flat surface for its installation.
Take a long string and tie it’s one end to a screwdriver. Cut the string to the length of your pool’s radius. Locate your preferred center point of the pool on the ground. Insert the screwdriver into the ground at this point.
Now, let the string guide you to mark the pool’s circumference using spray paint. If you have a rectangular pool, mark its length and width on the ground with spray paint. It is recommended to make markings after allowing an extra 1 or 2 inches away from the measured dimensions.
You can also make markings 18 inches away from the pool. This space can be utilized to place sand or other landscaping materials.
Refer to the instruction manual while selecting the pool’s location.
Once you’ve cleared the sod, level the ground using a tamper or lawn roller. These tools can help you compress the ground and create a safe base for your pool.
Now, use a spirit laser level to check if the ground has been leveled completely. If you’re using a spirit level, you must place it on several portions of the ground to check the level.
Place interlocking gym mats all across the pool base you just prepared. This will provide cushioning and support to the above ground pool. You can cut them easily with the help of scissors to fit them perfectly in the pool base.
Carefully lift up the interlocking gym mats and drag them away from the pool base. Locate the center of your circular pool and drive a stake into it. Connect this stake to a wooden plank that matches the radius of your pool. Make sure the plank is wide enough to place a spirit level on it.
Pour sand into the pool base area so that it forms a thin layer. Spread out the sand evenly using a rake. Rotate the wooden plank to check the level of different areas. Once the sand has been leveled perfectly, remove the plank and stake.
Carefully place the interlocking gym mats back on the pool base. Ensure that you do not disturb the sand too much. Walk all over the gym mats to compress them evenly.
Now follow the instruction manual to install the bottom wall rim. Assemble the plates, stabilizers and rim as per the manufacturer’s instructions. Next, attach the pool walls to the bottom ring.
Install the wall support and top cap as per the manual. Next, push the suction ports into the holes provided in the pool wall. The clamp will come right outside the wall. Similarly, push the inlet in one of the holes provided.
Connect different pipes in each of these suction and inlet points. The other end of these pipes must be connected to a water filter. Consult the manual to install the pump correctly.
Installing a sand filter can make it easier to clean the pool.
Fill your pool halfway with water and check for any water leaks. Repair the water leakage points and then fill the pool completely.
Many above ground pool kits include a top rail. If your kit has one, install the top plates and support posts using the hardware included in the kit. Your pool is ready to be used.