SteelTek DIY Custom Structural Pipe and Fittings Small Pipe Wall Shelf

Step 1 Start by installing the (6) Standard Railing Flanges to studs in your wall. Insert your (6) 6” pipes into all of the Standard Railing Flanges and tighten set screws. Measure according to the size of your vertical pipes. I Installed the middle Standard Railing Flanges a little higher so that the DVD cases rested on the top horizontal bars. Step 2 Take your (2) 18” pipes and slide a Single Socket Tee onto each one. Attach Elbows, to each end of (2) 18" pipes, so that the elbows and Single Socket Tees are facing the same direction then tighten set screws. Step 3 Attach (4) Elbows and (2) Single Socket Tees, connected to (2) 18” pipes, to open ends of (6) 6” pipe then tighten set screws. Step 4 Place wood peices on bottom and middle (4) 6” pipes and your small shelf is done. If you would like to secure the shelves down better we offer Offset Flanges that are perfect for the job. Just slide the Offset Flanges onto the bottom and middle 6” pipes. Secure with wood screws by going through the bottom hole of Offset Flange and into wood piece.