Ratings & Reviews for National Hardware 10-In x 1/1/4-In corner brace in zinc 10-in x 0.5-in x 10-in Zinc-plated Steel Chair brace
Ratings may include incentivized customer reviews.
What Customers Are Saying
The product is widely praised for its sturdiness, durability, and suitability for heavy-duty applications such as supporting shelves, decks, and ladders. Customers highlight the brackets' strength, rigidity, and ability to hold significant weight without bending or breaking. The brackets are described as easy to install, with pre-drilled holes and countersunk screw holes for a flush finish. While a few customers reported issues with quality and dimensions, the majority of reviews are extremely favorable.
Customer review summary generated by AI, including incentivized reviews.Poor quality & incorrect width spec
Would Not RecommendReturned product. 2 were bought. Both were poorly made. The bend angle of each was 87 to 88 degrees and one leg on each was bowed and did not lay flat. Also, the specification stated 0.50 inches wide. Actual was 1.00+ inches wide. Too wide for my project. The product was very sturdy and had a nice finish.
Verified Purchaser
Bike Garage
Would RecommendIt's Sturdy, Heavy Duty, not a bad price, considering Inflation of everything, I'm working on a 6 foot by 8 foot Bike Garage with a 9 foot Ceiling height, it's great for supporting the Crossbeams from the 4x6 Studs, which I got 3 foot in the ground encased in Concrete & laying a brick floor in it, which technically they'd be posts, but they're acting as the studs for the frame. which they also work good for the corner joints & might even use them to support the Truss for the roof, either that or...
Stanley angle iron review
Would RecommendThis is a very strong angle iron. It was the largest center can find in the store looks well made.
Great bracket
Would RecommendWent to buy a shelf bracket to hang 20 ft ladder under eve of barn and as I was walking thought hardware took a look at the size and thickness of these. I put the shelf bracket back and got the angle steel. Put in vice and hammered 1 inch of the end to form lip to keep ladder from easily slipping off and now holds two ladders. Very pleased.
Verified Purchaser
BRACE WAS NOT SQUARE.
Would RecommendI USED THE BRACES TO BUILD FOUR "C" TABLES, 2 BRACES TO EACH TABLE. UPON INSTALLING THE TOP, I REALIZED THAT THE BRACES WERE NOT SQUARE BECAUSE THE TABLE TOP WAS NOT LEVEL. THE BEND WAS ONLY 85 DEGREES, NOT 90. I HAD TO REMOVE THEM FROM THE TABLES AND TAKE THEM TO A MEDAL FABRICATION SHOP TO BE FIXED. THIS CAUSED TO TO LOOSE SEVERAL DAYS GETTING THE TABLES MADE. NEW SUBJECT, I AM RETIRED MILITARY HAVING SERVED IN BOTH THE USMC AND THE US ARMY. i VERY MUCH APPRECIATE THE 10% DISCOUNT YOU HA...
Verified Purchaser
Hi Bill,
Thanks so much for the feedback on the corner brace. We’re sorry for the extra work you encountered; we will share your comments ... Read More
making shelves for my shed
Would Recommenddurable and stable to hold my pots and pans.
Verified PurchaserSweepstakes
A strong corner bracket
Would RecommendI bought this bracket to reinforce the corner of my deck. It's very sturdy and does the job quite well. I especially like the way the screw holes are countersunk so the screw heads are flush. A nice touch.
Verified PurchaserSweepstakes
Great bracket
Would RecommendWas very helpful to make my installation a success
Verified PurchaserSweepstakes
Hello ajpost,
Thank you for posting a review. Your experience with our products is important to us and should you need further assistance... Read More